This KB can be used on SRX firewalls as well.


usually when you start the CRL request, installed the certs for local and CA, both cluster members will automatically synchronized for certs and keys between nodes since  PKI is supported in SRX cluster environment.

When one node lost their key and certs, following procedures can help to get them from another node.


SUMMARY:

This document explains how to copy certificates after RE replacement in HA cluster.

PROBLEM OR GOAL:

These certificates and key-pairs won’t get synched from other Node when new RE is replaced.
As the certificates does not get synched, the IPSEC tunnel using certificates will go down after failover to this Node (On which RE was replaced).

The certificates/key-pairs used for IKE negotiations are stored in following locations,

/var/db/certs/common/key-pair
/var/db/certs/common/local
/var/db/certs/common/certification-authority

SOLUTION:

Procedure is as follow

1. Start shell as root user on both cluster nodes in two sessions.
2. Verify content on source cluster node of first folder with “ls -la /var/db/certs/common/key-pair/”
3. Confirm do you have same file names on destination cluster node with same command.
4. If you have files with same names in destination folder, backup them with moving to some other location.

===
[email protected]% pwd
/var/db/certs/common/key-pair
[email protected]% ls -la
total 8
drwx—— 2 root wheel 512 Jan 22 15:09 .
drwx—— 7 root wheel 512 Mar 26 2009 ..
-rw-r–r– 1 root wheel 0 Jan 22 15:09 test
[email protected]% mv test test.old
[email protected]% ls -la
total 8
drwx—— 2 root wheel 512 Jan 22 15:10 .
drwx—— 7 root wheel 512 Mar 26 2009 ..
-rw-r–r– 1 root wheel 0 Jan 22 15:09 test.old
[email protected]%
===

5. From source cluster node copy files from first folder, make sure that you use correct node number for destination:
===
[email protected]% rcp -T /var/db/certs/common/key-pair/* nodex:/var/db/certs/common/key-pair/
===
6. Verify on destination cluster node do you have new file copied from first node with “ls -la”
7. Repeat steps 2 to 6 for each folder